Instruction manual

42 UltraLink 2 DVI Installation and Operation Manual
Behaviour for admin connections when limit reached – Replace oldest connection, Replace newest
connection, Don’t replace:
This setting determines how an admin connection request is handled when the maximum number of user
connections already exists. Either the oldest or the newest user connection must be disconnected to allow for
the new admin connection. If Don’t replace is selected, the admin user will not be connected.
Use VESA GTF:
When checked, the UL2-DVI will use the VESA Generalized Timing Formula to help determine the correct
input video resolution and timing details. Appendix D lists all supported video modes.
Upgrade Firmware:
This button puts the UL2-DVI into upgrade mode. Firmware upgrade is discussed in greater detail later in this
section.
Reset Unit:
This button causes the UL2-DVI to perform a cold reboot.
Time & Date Configuration
The Time & Date Configuration Screen is accessed by clicking the Time & Date Configuration button on the
UL2-DVI Configuration Screen. The UL2-DVI has a real-time clock which will maintain the date and time for a
few hours in the event of power loss.
Figure 55. Time & Date Configuration Screen
Time & Date:
Use the arrow keys to manually set the time (24-hour format) and the date.
Timezone specifier (e.g. EST5):
If Use NTP is selected, this field can be used to optionally provide the correct real time for the UL2-DVI
location. Enter the specifier for the local time zone in UTC time format.