Instruction manual

DECLARATIONS OF CONFORMITY
FCC Declaration of Conformity
This equipment generates, uses and can radiate radio frequency energy and if not installed and used properly,
that is in strict accordance with the manufacturer’s instructions may cause interference to radio communication.
It has been tested and found to comply with the limits for a Class A digital device in accordance with the
specifications Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection against
such interference when the equipment is operated in a commercial environment. Operation of this equipment
in a residential area is likely to cause interference, in which case the user at his own expense will be required
to take whatever measures may be necessary to correct the interference.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
European EMC directive 2004/108/EC
This equipment has been tested and found to comply with the limits for a Class A computing device in
accordance with the specifications in the European standard EN55022. These limits are designed to provide
reasonable protection against harmful interference. This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance with the instructions may cause harmful
interference to radio or television reception. However, there is no guarantee that harmful interference will not
occur in a particular installation. If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment on and off, the user is encouraged to correct the
interference with one or more of the following measures:
(a) Reorient or relocate the receiving antenna.
(b) Increase the separation between the equipment and the receiver.
(c) Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
(d) Consult the supplier or an experienced radio/TV technician for help.
Canadian Department of Communications RFI statement
This equipment does not exceed the Class A limits for radio noise emissions from digital apparatus set out in
the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de la classe A prescrites dans le règlement sur le brouillage radioélectriques publié par
le ministère des Communications du Canada.
Radio Frequency Energy
A Category 5 (or better) twisted pair cable must be used to connect the UltraLink 2 DVI unit in order to maintain
compliance with radio frequency energy emission regulations and ensure a suitably high level of immunity to
electromagnetic disturbances. All other interface cables used with this equipment must be shielded in order to
maintain compliance with radio frequency energy emission regulations and ensure a suitably high level of
immunity to electromagnetic disturbances.