Instruction manual

24 UltraLink 2 DVI Installation and Operation Manual
VNC Viewer Toolbar
The VNC Viewer toolbar contains buttons and controls to manage interaction with the host computer. A variety
of tools are available, from sending keyboard commands to controlling an attached power switch or invoking
Virtual Media. These tools are described in this section.
The toolbar also contains the Configure button, which allows further customization of the UL2-DVI
configuration. This is described in the Configuration section.
Figure 31 shows the VNC viewer toolbar and an explanation of each toolbar tab.
Figure 31. VNC Viewer Toolbar
Please note that the Hosts and Power buttons do not appear in the Viewer Toolbar during the Initial
Configuration of the unit. They will be present after the Hosts have been defined in the Hosts Configuration
Screen. This is described in the Configuration section.
The VNC Viewer toolbar can be customized so that only the desired buttons are displayed on the toolbar. This
can be done by the user at the toolbar, or by the administrator at the User Accounts Configuration screen. The
second method is described in the Configuration section.
A user must have the necessary rights to customize the toolbar. This is defined by the administrator in the User
Accounts screen, described in the Configuration section. If the user has the necessary rights, the toolbar can
be customized by clicking the right mouse button on the toolbar. This will display a drop-down menu as shown
in the figure below, where toolbar buttons can be added and removed.
Figure 32. Customizing the VNC Viewer Toolbar by Right-Clicking