Instruction manual

12 UltraLink 2 DVI Installation and Operation Manual
Figure 14. Setting Initial IPv4 network address
Change the IP Address, Network Mask, and Gateway to match that of the network the unit will be connected
to. The VNC port (5900) and HTTP Port (80) should only be changed if they conflict with existing network
settings. To use DHCP, check the “Use DHCP” field. When complete, “Save” the new IP information.
Note: When the unit has been configured and connected to the network, if the “Use DHCP” option was
selected, the IP address will change to whatever the DHCP server assigns it. To determine the new network
address, return to the Network Configuration screen, and the allocated network address will be displayed.
When network configuration of the UL2-DVI has been completed, change the IP information on the computer
used to connect to the unit back to the original values.