Instruction manual

8 UltraLink 2 DVI Installation and Operation Manual
Figure 5. Network connection
For Ethernet Connection to the UL2-DVI
 Connect the port labelled Link on unit to the Local Area Network or internet using a CATx cable.
Optional Connections
The UL2-DVI has two optional connections: to input audio from the host computer or KVM Switch, and to
provide a means to serially control a remote power switch. These connections are shown below.
Figure 6. Optional Serial and Audio connections
For Audio Input to the UL2-DVI
 Connecting to a host computer: Use the supplied 3.5 mm stereo jack cable to connect the audio jack
labeled In Audio to the audio output connector on the host computer.
 Connecting to a KVM switch: Use the supplied 3.5 mm stereo jack cable to connect the audio jack labeled
In Audio to the audio output connector on the User Console of the switch.
Note: Audio support through the UL2-DVI is only provided by the RealVNC Viewer that is included in the unit.
Later Viewers downloaded from the RealVNC website do not provide audio support.
For Serial Connection to a Remote Power Switch
 To control a remote power switch from the unit, connect the supplied serial power control cable between
the RS232 connector labeled Serial and the RJ-45 serial connector on the remote power switch.
Connections based on DIP Switch 1
The UL2-DVI can draw power from either two USB connections to the host computer or KVM Switch, or from
the optional AC power adapter. The position of DIP Switch 1 determines the source of its power.