Instruction manual

ORION LC Installation and Operations Manual
3
DDC Information
The Orion LC uses an internal DDC table that is compatible with the majority
of the connected monitors. This table normally does not need changing for
proper operation. It the default setting does not satisfy your system
requirements, the DDC information can be obtained from either the local or
remote monitor. See Appendix C for instructions.
Next Frame Switching
The transmission of screen data is not synchronous to the screen changes
of the graphic card. Normally, the transmission is terminated during the
display of a frame on the screen (at the remote unit). If the device switches
to the new frame during the displaying period of the old frame (somewhere
on the screen), it is possible that you will see horizontal screen breaks at the
moment of switching (default). On the other hand, if the device idles until the
actual frame is displayed completely (until VSYNC) then the number of
frames per second transmitted reduces. To modify the switching behavior,
refer to Appendix E.
KVM Transmitter and Receiver information
The configuration of the CATx or fiber extender transmitters and receivers
used will depend on the application.
Standard Models
Local Remote
Serial / Audio Models
Local Remote
Description
USB local
access
CRK-2DTXUD1D CRK-2DTXUD1D/AUD
USB Dual head
Local access
CRK-2DTXUD2D CRK-2DTXUD2D/AUD
The KVM extenders to use with each Orion LC application
(Multiplex Repeater, Cross-point switch, or KVM switch)
will depend on the application and if serial and audio are needed.