User's Manual

PAGE 1
PAGE 2
UltraMatrix Single unit Installation The following installation procedure features the 4XE model. Installation for other models (2, 4, or 8 computers) follow the same basic procedure. It is recommended that power to all monitors, computers, and UltraMatrix be off until all connections have been made. The below illustration shows the basic cable connections for UltraMatrix and the installation steps to properly connect the cables, computers, and KVM stations to UltraMatrix.
PAGE 3
Operating Instructions With all cabling in place and power applied to all equipment, the video monitor connected to KVM port #1 should display the video from computer #1 (default). Switching to other computers is accomplished by: 1. Keyboard commands (press and release left Ctrl key + CPU #) (LCtrl + 3 switches to port #3) 2. On-Screen-Display list of computers (Left Ctrl + Esc key) 3.
PAGE 4
Keyboard commands The following table describes the available keyboard commands. The [Ctrl] key sequence is a press and release of the left control key. Commands following [Ctrl] must be entered within 2 seconds. Command Key sequence Description Main Menu [Ctrl] [F12] Displays main menu CPU List [Ctrl] [Esc] Displays CPU selection list Direct CPU connect [Ctrl] n [Enter] Connects directly to the specific CPU number “n”.