User Manual

25
TF 200.01.0036_eng
4.4.4 Height-adjustable with high wall unit
(40-41140)
CONSTRUCTION
The wall must be made of a material
suited for screw mounting and approved
for damp rooms.
The hatched area is the minimum area
for reinforcement of the wall.
Reinforcement from floor to ceiling is
advisable.
Load-tested according to DS/ISO 17966
the maximum user weight has been fixed
at 80kg (176 lbs).
Max. tensile load of upper screws
88kg/screw (194lbs/screw)
The washbasin is supplied with a set of
12 screws and rawlplugs suitable for
mounting on a concrete wall. The fitter
should always consider the material,
condition and strength of the wall and use
screws and rawlplugs suitable for the
specific wall type.
PLUMBING
The drain hose is a flexible Ø32 (1 ¼”)
hose.
The water supply ends in 2 (two) 90° shut-
off valves with ½” or 3/8” outside thread
pointing downward (not included).
The flexible water connection hoses from
the washbasin end in Ø10 pipes. Adapter
fittings from these pipes to the shut-off
valves are available with Ropox and as
standard plumbing components.
If a location of the drain higher than the
recommended positioning is required,
there may be a risk of reduced draining
from the washbasin.
For purchase of adapters for connection to
various standard installations, see
”Connection Adapters – Swing
Washbasin”.
Note:
All dimensions are based on adjustment of
the washbasin from 750 - 900 mm (29 ½”
– 35 ½”) above floor level. If a change of
this height-adjustment range is required,
the recommended dimensions must be
changed accordingly.
226
8
57
/
64
”
186
7
21
/
64
”