User Manual

23
TF 200.01.0036_eng
4.4.2 Fixed height with high wall unit
(40-41120)
Construction
The wall must be made of a material
suited for screw mounting and
approved for damp rooms.
The hatched area is the minimum area
for reinforcement of the wall.
Reinforcement from floor to ceiling is
advisable.
Load-tested according to DS/ISO
17966 the maximum user weight has
been fixed at 80kg (176 lbs).
Max. tensile load of upper screws
88kg/screw (194lbs/screw)
The washbasin is supplied with a set of
8 screws and rawlplugs suitable for
mounting on a concrete wall. The fitter
should always consider the material,
condition and strength of the wall and
use screws and rawlplugs suitable for
the specific wall type.
Plumbing
The drain hose is a flexible Ø32 (1 ¼”)
hose.
The water supply ends in 2 (two) 90° shut-off
valves with ½” or 3/8” outside thread pointing
downward (not included).
The flexible water connection hoses from the
washbasin end in Ø10 pipes. Adapter fittings
from these pipes to the shut-off valves are
available with Ropox and as standard plumbing
components.
If a location of the drain higher than the
recommended positioning is required, there
may be a risk of reduced draining from the
washbasin.
For purchase of adapters for connection to
various standard installations, see ”Connection
Adapters – Swing Washbasin”.
Note:
All dimensions are based on a washbasin
height of 800mm (23 5/8”) above floor level. If a
change of this height is required, the
recommended dimensions must be changed
accordingly.
226
8
57
/
64
”
186
7
21
/
64
”