User Manual

22
TF 200.01.0036_eng
4.4 Installation interfaces
4.4.1 Fixed height with low wall unit
(40-41110)
Construction
The wall must be made of a material
suited for screw mounting and approved
for damp rooms.
The hatched area is the minimum area
for reinforcement of the wall.
Reinforcement from floor to ceiling is
advisable.
Load-tested according to DS/ISO 17966
the maximum user weight is 80kg (176
lbs).
Max. tensile load of upper screws
88kg/screw (194lbs/screw)
The washbasin is supplied with a set of 8
screws and rawlplugs suitable for
mounting on a concrete wall. The fitter
should always consider the material,
condition and strength of the wall and use
screws and rawlplugs suitable for the
specific wall type.
Plumbing
The drain hose is a flexible Ø32 (1 ¼”)
hose.
The water supply ends in 2 (two) 90°
shut-off valves with ½” or 3/8” outside
thread pointing downward (not included).
The flexible water connection hoses from
the washbasin end in Ø10 pipes.
Adapter fittings from these pipes to the
shut-off valves are available with Ropox
and as standard plumbing components.
If a location of the drain higher than the
recommended positioning is required,
there may be a risk of reduced draining
from the washbasin.
For purchase of adapters for connection
to various standard installations, see
”Connection Adapters – Swing
Washbasin”.
Note:
All dimensions are based on a
washbasin height of 800mm (21 1/2”)
above floor level. If a change of this
height is required, the recommended
dimensions must be changed
accordingly.