Ropox Swing Wash Basin Fixed height or manual height adjustment User Manual & Mounting Instructions Keep this folder with product at all times! TF 200.01.
Table of content 1. SYMBOLS USED IN THIS MANUAL .............................................................................................. 3 2. GENERAL SAFETY ........................................................................................................................ 3 2.1 Product Unit label ................................................................................................................ 5 3. GENERAL REQUIREMENTS............................................................
1. Symbols used in this manual Warning Symbol Indication of potentially hazardous situation. If not avoided, it can result in serious injury or death. Caution Symbol Indication of potentially hazardous situation which may result in minor or moderate injury. It may also be used to alert against unsafe practices. Notification Symbol This symbol is used to notify correct use and handling of the product. 2. General safety This manual must be read and understood before use.
Do not perform repairs, disassembly or assembly operations, add-ons, re-adjustments or modification of the product beyond what is described in this manual. These must be carried out by Ropox or Ropox authorized personnel. Do not perform service while in use.
2.1 Product Unit label 40-41110-7 Wash basin Ropox Swing Washbasin, Fixed Short cover. Plumbing is visible Max load: 80kg Mass of product: 14kg This product is UKCA-marked in accordance with: UK SI 2002 No. 618 - The Medical Devices Regulations 2002, and its amendments UK SI 2008 No.
3. General requirements 3.1 Product information Manufacturer Ropox A/S Ringstedgade 221, DK-4700 Naestved +45 55 75 05 00 Email: Info@ropox.
3.6 Non-clinical functions Height adjusting offers better ergonomics to the user. 3.7 Clinical functions This product does not offer clinical benefit for patients, when used as intended by the manufacturer. 3.8 Product dimensions 40-41110 226 8 57/64” 186 40-41120 7 TF 200.01.
40-41130 40-41140 NB: All dimensions are in mm and inches 8 TF 200.01.
3.9 Connection adapters The highlighted components can be bought separately depending on the type of building installation requirements. Water supply Swing Wash Basin Hose from basin Installation in room Adapters (not included) z 10mm -> 1/2" Item no. 97001667 1/2" Thread 10mm -> 3/8" Item no. 97001668 3/8" Thread 10mm -> 15mm Item no. 97001665 15mm Pipe 10mm (3/8”) Water hose extensions Hose from basin Coupling piece Extra hose 1/2" x 1/2", 0,5m, steel Item no.
3.10 Layout proposals 10 TF 200.01.
4. Instruction for use 4.1 Operating the product Ropox Swing Wash Basin has a turning function, which means that it is NOT allowed to be used as a walking or standing support. If the wash basin is locked in the Dock-in it functions as a standard wash basin and is safe to use as a standing support. Maximum Loads Locked in dock-in (sold separately) A 245kg/539lbs person is able to lean on the basin while standing, without causing any significant deformation or safety risk.
4.2 Adjusting the height Warning! The product should always be able to travel the full range of actuation without colliding with objects. Failing to do so will compromise the product stability. 12 TF 200.01.
4.3 Installation of product Warning! The fitter should always consider the material, condition and strength of the wall and use screws and rawlplugs suitable for the specific wall type. 4.3.1 Model 40-41110 + 40-41120 The screws and raw plugs included are for mounting on a concrete wall. The installer must always examine the material, condition and strength of the wall and use appropriate screws and raw plugs. Maximum load in the top screws are 190lbs.
40-41110 2 1 40-41120 2 1 14 TF 200.01.
40-41110 Ø32mm - 1 ¼” 40-41120 Ø10mm - 3/8” Ø10mm - 3/8” 15 TF 200.01.
40-41110 2 1 40-41120 2 1 16 TF 200.01.
4.3.2 Model 40-41130 + 40-41140 The screws and raw plugs included are for mounting on a concrete wall. The installer must always examine the material, condition and strength of the wall and use appropriate screws and raw plugs. Maximum load in the top screws are 88kg/190lbs. The measurements on the wall, shown below, enable the wash basin to be height adjusted 750-900m / 29 17/32 ”– 35 7/16’’from the floor. 40-41130 40-41140 40-41130 40-41140 17 TF 200.01.
40-41130 40-41140 Ø32 - 1 ¼” Ø10 - 3/8” Ø10 - 3/8” 18 TF 200.01.
40-41130 19 TF 200.01.
40-41140 40-41140 20 TF 200.01.
40-41140 40-41140 Note! If the wash basin is delivered with a touchless mixer tab, this might need to be calibrated to accommodate the specific light settings in the room as well as any individual user needs. The calibration has to be done according to the user manual of the mixer tab which is supplied with the wash basin. 21 TF 200.01.
4.4 Installation interfaces 4.4.1 Fixed height with low wall unit (40-41110) Construction The wall must be made of a material suited for screw mounting and approved for damp rooms. The hatched area is the minimum area for reinforcement of the wall. Reinforcement from floor to ceiling is advisable. Load-tested according to DS/ISO 17966 the maximum user weight is 80kg (176 lbs). Max.
4.4.2 Fixed height with high wall unit (40-41120) Construction The wall must be made of a material suited for screw mounting and approved for damp rooms. The hatched area is the minimum area for reinforcement of the wall. Reinforcement from floor to ceiling is advisable. Load-tested according to DS/ISO 17966 the maximum user weight has been fixed at 80kg (176 lbs). Max.
4.4.3 Height-adjustable with low wall unit (40-41130) Construction The wall must be made of a material suited for screw mounting and approved for damp rooms. The hatched area is the minimum area for reinforcement of the wall. Reinforcement from floor to ceiling is advisable. Load-tested according to DS/ISO 17966 the maximum user weight has been fixed at 80kg (176 lbs). Max.
4.4.4 Height-adjustable with high wall unit (40-41140) CONSTRUCTION The wall must be made of a material suited for screw mounting and approved for damp rooms. The hatched area is the minimum area for reinforcement of the wall. Reinforcement from floor to ceiling is advisable. Load-tested according to DS/ISO 17966 the maximum user weight has been fixed at 80kg (176 lbs). Max.
5. Safety in use ➢ The Ropox Swing Wash Basin should only be used by people, who have read and understood these instructions. ➢ Always use the washbasin so there is no risk of damage to people or property. The person, who operates the Ropox Swing Wash Basin, is responsible for avoiding damage or injury. ➢ Children or persons with reduced observation capability should only use the washbasin when supervised.
6. Cleaning Note! Do not use cleaning agents containing abrasive e.g. scouring powder, steel wool, scouring sponge. This product is not designed to be sterilized, autoclaving and sterilization beyond normal cleaning is may possibly change the product safety and function. 6.1 Cleaning of the wash basin It is important that the wash basin is cleaned according to these guidelines. Clean the washbasin with a wrung cloth with lukewarm water and a mild detergent. Do not use abrasives or grinding cloths.
8. Components part list Note! Ropox will make parts list available for extraordinary maintenance and repair beyond what is described in this manual. Repair beyond what is described in this manual may only be done by Ropox designated service personnel. 9. Environmental protection The product is not intended to be disposed as municipal waste. Proper disassembly, sorting and disposal of components must be done by waste disposal professionals.
