User Manual

Side 23

User Information

Functional test

After completed installation and before use, all functions of the Ropox Lateral Adjustment

System with Support Washbasin must be tested. After that, a functional test must be

carried out at least once a year by competent personnel.

1. Check that the mounting instructions have been observed.

2. Check that all screws and bolts have been securely tightened.

3. Check that drain and hoses have been correctly connected.

4. Check that there is no load on the frame.

5. Check that there are no objects preventing the frame from moving freely within the

height and lateral adjustment range.

After successful functional test, the Ropox Lateral Adjustment for Support Washbasin is

ready for use. See ”Safety instructions”.

Safety instructions

➢ The Lateral Adjustment System should only be operated by persons, who have read

and understood these instructions.

➢ For some models of Ropox Lateral Adjustment the Support Washbasin is height-

adjustable and should not be used as a lifting table or person lifter.

➢ Always use the product in a manner excluding the risk of damage to persons or

property. The person operating the unit is responsible for avoiding damage or injury.

➢ When using the system in publicly accessible environments where children or

persons with reduced observation capability may get near the washbasin, the

person operating the washbasin must be very careful in order to avoid dangerous

situations.

➢ Make sure that there is free space above, below and beside the washbasin for

lateral and height adjustment.

➢ Do not overload the lateral adjustment system and make sure that the load

distribution is correct.

➢ Do not operate the system in case of errors or damage.

➢ Modifications, which may influence the operation or construction of the lateral

adjustment system for Support Washbasin are not allowed.

➢ Installation, service and repairs should only be carried out by competent personnel.

➢ During inspections, service or repairs, load must be removed from the unit

Service and maintenance

The product may get dirty during use. It is very important to clean the system according to

these instructions. Wash with a wrung cloth with lukewarm water and an ordinary cleaning

agent. Do not use etching/grinding liquids or grinding cloths, brushes or sponges.