User Manual

Page 5
© ROPOX 2015
Ropox Verti Electric
Cabinet width 40-180 cm / 15,7 – 70,8 in (30-40604 to 30-40618)
Assumptions for schematic diagram:
Cabinet height = 704 mm / 27,7 in – (for other cabinet heights the
dimension sketch will be changed accordingly)
(The frame is designed for cabinet heights from 704-920 mm / 27,7-
36,2 in.)
Construction – see dimensions on the following page
Minimum area for reinforcement of wall. Wall material must be suitable
for screw mounting.
Area for electric installation.
Area for conduit.
Cable for operation must be laid from the cabinet to the front edge of the
worktop for mounting of the control switch. We recommend the installation
of an empty pipe conduit in the wall to accommodate the cable (ø3.5cm).
If a high cabinet stands in the immediate vicinity of the Verti Electric, the
cable may be run through the cabinet to avoid the conduit in the wall.
40 – 120 cm / 15,7 – 47,2 in
Max. load 80kg/176lb evenly distributed, according to DS/EN 12182, based
on 11 screws/bolts.
130 – 180 cm / 51,2 – 70,8 in
Max. load 120kg/264lb evenly distributed, according to DS/EN 12182, based
on 22 screws/bolts.
Minimum load capacity per screw/bolt:
22.5kg/49lb
The fitter should always consider the material, condition and strength of the
wall and use screws and rawlplugs suitable for the specific wall type.
Motor is placed inside the cabinet:
For double unit 130-180 cm / 51,2 – 70,8 in, it is not possible to mount
cabinet sizes smaller than 60 cm / 23,6 in on the right side, due to motor
placement inside the cabinet.
///////////////
150
330
50 mm ± 1
300 mm / 11,8 in
(704-920 mm)
704
Lower edge of
cabinet
1416
230V
2 in
1672
13 in
5,9 in
65,8 in
55,7 in
mm
mm
mm
mm
mm
27,7 – 36,2 in