User Manual

Ropox Diagonal
Cabinet width 40-180 cm / 15,7 – 70,8 in (30-40904 to 30-40918)
Assumptions for schematic diagram:
Cabinet height = 704 mm / 27,7 in – (for other cabinet heights the
dimension sketch will be changed accordingly)
(The frame is designed for cabinet heights from 704-920 mm / 27,7-
36,2 in.)
Height upper edge of wall cabinet = 2120 mm / 83,5 in (for other
cabinet heights the dimension sketch will be changed accordingly)
Construction – see dimensions on the following page
Minimum area for reinforcement of wall. Wall material must be suitable
for screw mounting.
Area for electric installation.
Area for conduit.
Cable for operation must be laid from the cabinet to the front edge of the
worktop for mounting the control switch. We recommend the installation of a
conduit in the wall to accommodate the cable (ø3.5cm).
If a high cabinet stands in the immediate vicinity of the Diagonal, the cable
may be run through the cabinet to avoid the conduit in the wall.
40 – 120 cm / 15,7 – 47,2 in
Max. load 120kg/264lb evenly distributed, according to DS/EN 12182, based
on 9 screws/bolts.
130 – 180 cm / 51,2 – 70,8 in
Max. load 220kg/485lb evenly distributed, according to DS/EN 12182, based
on 18 screws/bolts.
Minimum load capacity per screw/bolt:
60kg/132lb
The fitter should always consider the material, condition and strength of the
wall and use screws and rawlplugs suitable for the specific wall type.
(704 – 920 mm)
*
230V
150
7 in
mm
mm
mm
mm
mm
mm
* For cabinet height 704 mm / 27,7 in
115±3 mm
mm
4,5 in
13 in
5,9 in
83,5 in
64 in
16,5 in
55,7 in
27,7 – 36,2 in