Specifications

14 ST-133/ST-133A Controller Manual Version 2.H

3. Confirm the fuse ratings by removing the white fuse holders. To do so, simply insert

the flat blade of the screwdriver behind the front tab of each fuse holder and gently

pry the assembly out.

After inspecting and if necessary, changing the fuses, reinstall the holders with the

arrow facing to the right.

5. Close the power module and verify that the correct voltage setting is displayed.

Computer Requirements

Host Computer Type

Note: The following information is only intended to give an approximate indication of

the computer requirements. Please contact the factory to determine your specific needs.

PC System

• AT-compatible computer with 80486 (or higher) processor (50MHz or faster),

Pentium or better recommended.

• Windows

95 (or higher) or Windows NT

(version 4.0 or higher) operating

system.

• High speed PCI serial card or at least one unused PCI card slot. Computers

purchased from Roper Scientific are shipped with card installed.

• Minimum of 32 Mbyte of RAM for CCDs up to 1.4 million pixels. Collecting

multiple images or spectra at full frame or high speed may require 128 Mbytes or

more of RAM.

• CD-ROM drive

• Hard disk with a minimum of 80 Mbytes available. A complete installation of

the program files takes about 6 Mbytes and the remainder is required for data

storage, depending on the number and size of images or spectra collected. Disk

level compression programs are not recommended.

• Super VGA monitor and graphics card supporting at least 256 colors with at

least 1 Mbyte of memory. Memory requirement is dependent on desired display

resolution.

• Two-button Microsoft compatible serial mouse or Logitech three-button

serial/bus mouse.