Specifications

108 ST-133/ST-133A Controller Manual Version 2.H
Installation
1. Remove the expansion slot cover on the rear panel of the I/O slot selected.
2. Insert the ISA Serial Interface card as far as possible into the appropriate ISA
socket. Then secure the Serial Buffer Board by reinstalling the expansion slot
cover screw.
3. Connect the serial cable to the 9-pin cable on the ISA Serial Buffer Board
mounting panel. The other end of the serial cable connects to the SERIAL COM
connector on the Interface Control Module panel. Take care to tighten the screws
at both ends of the cable using a small, flat-bladed screwdriver.
Figure 57. ISA board switch and jumper settings