BY WHIRLPOOL \ CORPORATION ELECTRICRANGE Jse & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-44-ROPER (1-800-447-6737). or visit our website at... www.roperappliances.com Table of Contents ...................................................
TABLEOF CONTENTS RANGE SAFETY ............................................................... The Anti-Tip Bracket ......................................................... 3 3 PARTS AND FEATURES .................................................. 6 COOKTOP USE ................................................................... Control Knobs ................................................................... Coil Elements and Burner Bowls ...................................... Home Canning ..............
RANGESAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety will follow the safety alert symbol and either the word "DANGER" or This is themessages safety alert symbol. "WARNING.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electrical shock, injury to persons, or damage when using the range, follow basic precautions, including the following: • WARNING: TO REDUCE THE RISK OF TIPPING OF THE RANGE, THE RANGE MUST BE SECURED BY PROPERLY INSTALLED ANTI-TIP DEVICES. TO CHECK IF THE DEVICES ARE INSTALLED PROPERLY, SLIDE RANGE FORWARD, LOOK FOR ANTI-TIP BRACKET SECURELY ATTACHED TO FLOOR, AND SLIDE RANGE BACK SO REAR RANGE FOOT IS UNDER ANTI-TIP BRACKET.
IMPORTANT SAFETY INSTRUCTIONS • Keep Oven Vent Ducts Unobstructed. For self-cleaning ranges - • Placement of Oven Racks - Always place oven racks in desired location while oven is cool. If rack must be moved while oven is hot, do not let potholder contact hot heating element in oven. • DO NOT TOUCH HEATING ELEMENTS OR INTERIOR SURFACES OF OVEN - Heating elements may be hot even though they are dark in color. Interior surfaces of an oven become hot enough to cause burns.
PARTSAND FEA'IURES This manual covers several different models. The range you have purchased may have some or all of the items listed. The locations and appearances of the features shown here may not match your model. Control Panels 1 2 3 [ .i 4 5 I 6 7 1 8 3 9 2 I 4 5 6 1. Electronic Clock/Timer (on some models) 2. Oven Indicator Lights 3. Oven Temperature Control 4. Surface Burner Loeator 5. Left Front Burner Control 6. Left Rear Burner Control 7. Surface Heating Indicator Light 8.
COOl(TOP USE . oil len en% an
Home Cookware Canning When canning for long periods, alternate the use of surface cooking areas, elements or surface burners between batches. This allows time for the surrounding areas to cool. • Center the canner on the grate or largest surface cooking area or element. Canners should not extend more than 1 in. (2.5 cm) outside the cooking area. • Do not place canner on two surface cooking areas, elements or surface burners at the same time.
T mef OVEN USE Etectroio ic The Timer can be set in minutes and seconds or hours and minutes and counts down the set time. The Timer does not start or stop the oven. ..Jocki [t -ner To Set: 1. Press TIMER. 2 3 The colon will flash during Timer programming. Ii. To display the time of day while the Timer is counting down, press CLOCK. Time of day will be displayed 5 seconds before returning to the Timer countdown. 2. 3. Press the "up" or "down" arrow pads to set length of time. Press TIMER.
To Adjust Oven Temperature Calibration (on models with manual oven control): 1. Make sure the oven temperature control knob is in the Off position. Pull oven temperature control knob straight off and turn it over. IMPORTANT: Do not line the oven bottom with any type of foil, liners or cookware because permanent damage will occur to the oven bottom finish. • Do not cover entire rack with foil because air must be able to move freely for best cooking results.
ai
To Broil: 1. Push in and turn oven control knob to BROIL. RANGECARE On some models, set the oven selector and oven temperature control knob to BROIL. The OVEN ON indicator light will turn on. 2. After broiling, turn the oven control knob to OFE On some models, turn both the oven selector and oven temperature control knob to OFE The OVEN ON indicator light will turn off.
How the Cycle Works IMPORTANT: The heating and cooling of porcelain on steel in the even may result in discoloring, loss of gloss, hairline cracks and popping sounds. Do not remove the cooktop to avoid product damage. The Self-Cleaning cycle uses very high temperatures, to a powdery ash. For more information, • Steel wool pad burning soil The oven is preset for a 3 hour 30 minute clean cycle, but the time can be changed.
4. Insert the door stop clip with the angular surface at the top of the frame hinge slot, then push in the bottom of the clip until flanges are flush with the front frame. 5. Open the door completely and remove the door removal pins. Save door removal pins for future use. Close the door. For normal range use, it is not suggested to remove the oven door. However, if necessary, follow these instructions. The oven door is heavy. Before Removing: 1.
Oven temperature • too high or too low Does the oven temperature calibration need adjustment? See "Oven Temperature Control" section. Oven indicator • lights flash Do the OVEN ON and HEATING indicator lights flash? See "Assistance or Service" section. • Do the HEATING and DOOR LOCKED/CLEANING indicator lights flash? The door lock has failed. See "Assistance or Service" sections. .................................................
ROPEP RANGEWARRANTY ONE-YEAR FULL WARRANTY For one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation will pay for FSP® replacement parts and repair labor costs to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company. Whirlpool Corporation will not pay for: 1.
