Room boost Room boost 700 MHz 4G LTE AT&T T-Mobile Booster instruc on Room boost Signal booster Model: HT2018001 Package Contents 1.Booster 2.Outside Panel Antenna with RG58 Cables(50 or 45 feet) 3.Power Adapter 4.Inside Whip Antenna 5.Moun ng Screw Kit 6.
1.Find the Strongest Signal Take your cell phone and walk around the house where you need to install the Booster . You can find the loca on of the strongest signal, and the outdoor antenna is best installed in this loca on. 2.Outside Antenna Installa on The outdoor antenna must be installed on the roof or height. There is no shelter around the antenna. The antenna is fixed on the pole.
.Connect Cables to Booster Next, the cable of the outdoor antenna is introduced into the room. No ce that the cable does not have a bending of less than 60 degrees so as not to damage the cable to affect the performance. Connect the cable to the outside joint of the booster Intside Antenna Power Adapter 4.
5.Connect Power Supply Finally, the power is turned on, if your mobile phone signal has been enhanced, Congratula ons, you succeed. If you are not very sa sfied with the intensity, then adjust the angle of the outdoor antenna un l you feel the cell phone signal is sa sfied. *WARNING: 1.The booster is designed for use in indoor ONLY. 2.Do NOT cover the booster body with anything. This prevents if from cooling down. If the product becomes overheated, it will automa cally shut off or cause permanent damage. 3.
Antenna Kitting Information Gain/Loss Component Prod No. Descrip on Outside Cable HT240 45Feet 698~787M 824~894 1850~1990 1700MHz\2100 HZ MHz MHz MHz 2.9dB 3.3dB 4.8dB 4.8dB\5.2dB Outside Cable HTG58 45Feet 6.9dB 7.5 dB 11.7 dB 11.1dB \12.3dB Outside Cable HT400- 75Feet 4.2dB 4.4dB 6.1dB 5.8dB\6.5dB Inside Cable HTG6 75Feet 3.5dB 4.1dB 6.2dB 5.5dB\6.9dB Inside Cable HTG6 45Feet 2.1dB 2.4 dB 3.7dB 3.3 dB\4.1dB Inside Cable HT240 90Feet 5.8dB 6.7 dB 9.7 dB 9.6dB\10.
Descrip on of network protec on features: This booster including safeguards to protect the cellular network from interference. Each Signal Booster is individually tested and factory set to ensure FCC compliance. 1.The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. 2.The Signal Booster will amplify, but ONLY incoming and outgoing signals in order to increase coverage of authorized frequency bands. 3.
