Assembly Instruction

Conversion to Toddler Bed: The crib mattress should be in lowest
position (Bolts in the lowest holes.) Remove the front Side by undoing
what you did in Step 4. Remember to loosen ALL Decorative Bolts
before attempting to remove the Side. Use the bolts and lock washers
you removed to attach the Toddler Rail as in Step 4.
THIS CRIB MAY NOT BE USED AS A TODDLER BED
WITHOUT A TODDLER RAIL.
For Toddler Bed use, the minimum age shall be no less than 15
months and the maximum weight shall not be greater than 50 lb
(22.7kg). The mattress intended for use on the bed shall be a full-size
crib mattress having minimum dimensions of 51.625 in. (131cm) in
length and 27 ¼ in. (69cm) in width and thickness of no less than 4 in.
(11mm) and not exceeding 6 inches (15cm).
Maintenance: Periodically check to make sure all screws, bolts and
fastening devices are tight. Before each usage or assembly, inspect crib
for damaged hardware, loose joints, missing parts or sharp edges. DO
NOT use crib if parts are missing or broken. DO NOT substitute parts.
DO NOT make any alteration to this crib.
Cleaning: Mix a mild solution of gentle dishwashing liquid and water,
apply to crib surface using a soft, clean cloth, then dry all surfaces with
a soft, dry cloth. NO ABRASIVES, SCOURING PADS, STEEL
WOOL, OR COARSE RAGS should be used to clean this fine furniture.
Storage: A Plastic Pouch is attached to the crib spring for storage of
the assembly instructions for future referral. After completing the
assembly, you are advised to read and be aware of all WARNINGS,
CAUTIONS, CLEANING, STORAGE AND MAINTENANCE notices
contained herein. We caution you not to place excess hardware in the
plastic pouch as it could present danger to a child if retrieved and it
could also puncture the crib mattress. When storing crib, use CAUTION
as extreme temperature or humidity changes could be harmful.
PARTS INCLUDED IN CARTON
1 – BASE PANEL WITH FEET 2 – END PANELS 2 – SIDES 1 – MATTRESS SUPPORT PLATFOR M
PARTS INCLUDED IN HARDWARE BAG
18 – DECORATIVE BOLTS 1 – BALL END ALLEN WRENCH 18 – LOCK WASHERS