Assembly Instruction

Riley Twin Bunk Bed Assembly Instructions

List of parts: 2 - high ends

2 - low ends

4 - side rails

2 - slat rolls

2 - guard fences (one full length,one 60

/4")

1 - bunk ladder

Hardware: 17 - 1

/4" coarse thread “bugle” screws

(black) to attach slats and guard fences

4 -

/2" coarse thread “bugle” screws (silver) to attach ladder

4 - 4" metal pins to secure top bed to bottom bed

Tools needed: phillips screwdriver

rubber mallet

Directions:

1. Hold one high end upright near its desired placement.

2.With metal face of side rail facing inward, insert round metal

connectors of side rail into the holes on headboard. Tap with

rubber mallet to ensure locked position. Repeat with other side rail.

3. Attach other end of side rails to other high end as in step 2.

4. Insert four 4" metal pins into holes on high ends. See DiagramA.

low end

high end

ladder

/4" guard fence

full-length guard fence

12/17/07

PAGE 1
Riley Twin Bunk Bed Assembly Instructions List of parts: full-length guard fence 2 - high ends 2 - low ends 4 - side rails 2 - slat rolls low end 2 - guard fences (one full length, one 601/4") 1 - bunk ladder Hardware: 17 - 11/4" coarse thread “bugle” screws (black) to attach slats and guard fences 4 - 1/2" coarse thread “bugle” screws (silver) to attach ladder 4 - 4" metal pins to secure top bed to bottom bed Tools needed: high end phillips screwdriver rubber mallet Directions: 1.
PAGE 2
5. Place low end (with holes pre-drilled into the bottoms of their legs) on top of the steel pins. Pull down on low end until flush with high end posts. Use rubber mallet if necessary to insure low end posts are flush with high end posts. See Diagram A. Diagram B 601/4" guard fence 6. Attach side rails to low end. 7. Place slat role on side rail cleats of both top and bottom bunk, spacing evenly from headboard to footboard. side rail 8.
PAGE 3
Safety Warnings 1. Follow the information on the warnings appearing on the upper bed end structure. Do not remove warning label from bed. 2. Always use the recommended size mattress to help prevent the likelihood of entrapment or falls. 3. Surface of mattress must be at least 5 in. (127 mm) below the upper edge of guard fences. 4. Do not allow children under 6 years of age to use the upper bunk. 5. Do not allow more than one person on upper bunk. 6.