Product Manual A

Mounting

Slot

Screw Holes

Assembly Instructions TP250/400 Secondary Handle Kit #48468

(Purchased Separately)

Allows use of a left side handle to engage the motor and carriage. It is highly recommended when using

with the Solar/Plywood Saddle Carriage. Can be used for both TP250 & TP400 models.

Step 1

Lay the base section ﬂat on a hard surface. Locate the mounting

slot and holes on the bottom portion of the base section.

Step 2

With one hand, hold the pivot/brake weldment just above the lower base section. Slide the mounting plates over

the pivot/brake rod. Make sure the raised hole side of the mounting plates goes on the inside.

Step 3

Using the two holes provided; insert two screws per side.

Tighten screws using a screw driver or wrench.

Parts included with the Secondary Handle Kit:

1 Handle

2 Pivot/Brake Weldmont

3 2 - Mounting Plates

4 4 - Screws

Secondary Handle Kit Assembly

Step 4

Attach secondary handle

to either side.