Product Manual A

Engine/Motor Base Placement

Step 1

Mount the motor assembly to the base unit; from behind the hoist; the foot pad of the motor base slides

under the track base section, while “hanging” the motor base. The motor assembly arms must ﬁt outside the

two retainer rings shown above.

Step 2

Before starting the engine...

Align the “V” belt to the large pulley on the base (next

to cable drum assembly on track base). Then slide the

belt under the belt guard longways to the motor base

(shown right). Lift the rear of the engine base, this

will make it much easier to place the V belt over the

engine pulley.

Step 3

Slide the brake handle over the brake arm

and tighten thumb screw provided. Brake

handle can the placed on either side of the

hoist, which ever is comfortable and safe.

Retaining

Rings

Engine Base Support Arms

Engine Pully

Lift here to

to install V-belt to pully

Engine/Motor Base Placement

Lift Engin

Base Here

Tighten

Thumb

Screw