Product Manual A

1/2” Washer

1/2” Lock Washer

1/2”x 1-3/4” Bolt

Feed end cable

through pully

Unwind cable

from the back

Attach cable to

the back of the

carriage (cross bar)

Attach brake handle

and pull downward

to release cabel drum

Step 10

Attach cable to the carriage assembly, pass

bolt through lock washer, washer and

cable end/eye. Tighten bolt as shown right.

You have completed the assembly of the TP250 Hoist

Skip to page 11 for Operation and Placement Instructions.

Step 8

Turn the hoist on its side, and working from the

back, remove the end of the cable from the drum

(shown right). It helps to attach the brake handle,

use the brake handle to release the brake drum.

The cable will then easily un-spool. Staying on

the outside (back) of the base section and track

section, take the cable to the top of the last track

section where the top cap pulley is attached.

Step 9

Feed the cable end through the pulley as shown

above , and down the front side of the track

section to the back of the carriage assembly.

TP250 Assembly Instructions