Product Manual A

Step 10

Feed the cable end through the pulley from

the back as shown above, return the cable to

the back side of the carriage.

Step 12

Remove the nyloc nut/washer/lock washer,

from the top cap assembly, place the eye end

over the bolt, replace the washer/lock washer

and tighten the nyloc nut as shown right.

Step 11

Feed the cable end through the pulley on

back of TP400 carriage.

Return the cable end to the top cap.

Back to the Top Cap

Front

Feed end cable

through pully

Unwind cable

from the back

Double back/feed end

cable through pully on

back of the carriage

Attach brake handle

to release cabel drum

Step 9

Turn the hoist on one side, from the back side of the

hoist, remove the end of the cable from the drum

(shown below). It helps to attach the brake handle,

use the brake handle back releases the brake drum.

The cable will then easily un-spool. Staying on the

outside (back) of the base section and track section,

pull the cable to top cap on the last track section.

Nyloc Nut

Lock Washer

Washer

Cable “Eye” End

You Have Completed the TP 400 Carriage Assembly

TP400 Assembly Instructions