Owners manual

Each strap has 2 sections: Top Strap (shorter) and Inside Strap (longer).
1. Slide a Top Strap under 2 strap guides, left-to-right.
2. Open the front doors of the car, run the Inside Strap across the interior, and connect buck-
les to the Top Strap until they click.
3. Repeat for other strap.
Pull the free ends
of the straps to
tighten straps
snug, but not over-
tight.
Over-tight straps
may deform door
seal and allow rain-
water into the car.
2-door cars
Rear strap: should enter the car at
the top-rear corner of door frame,
and should slant down-forward.
Front strap: enter the car at least
8” in front of rear strap, and should
be vertical or slant slightly down-
rearward.
Optional Pillar Installation
(only for 11 c.f. carrier)
Install Top Straps first.
Connect one end of an Inside Strap
to a Top Strap, wrap it around the
pillar, as shown, go back up and
connect to the other Top Strap.
Install the other Inside strap
around the pillar on the other side
of the car, and adjust length as re-
quired.
Car or Van WITHOUT Rack
Page 5