Instructions / Assembly

TIE DOWN ENGINEERING • Atlanta, GA 30336
www.tiedown.com [phone]
Ladder Stabilizer & Stand-off
Assembly Diagram
Part #48589
A
H
H
F
C
C
B
C
C
C
D
G
E
D
D
E
E
D
E
D
E
D
E
C
B
A
WARNING
• Never exceed maximum intended load of ladder
• Ladder side rails must extend at least 3 ft. above upper landing surface
• Never stand on rung above The Ladder Stabilizer
• Never stand on or use the tie bar to hold weight
• Use extreme caution and maintain balance when using Ladder Stabilizer
• Never use The Ladder Stabilizer if damaged or missing fasteners
• Always make sure that Ladder Stabilizer is secured with tethering pins prior to each use
• Never overstretch, keep waist within the ladder rails
• Stay 14 feet away from energized power lines
# Parts Qty.
A Left and Right Side Rail 2
B Upper and Lower Step Bracket 2
C 1/4”-20 x 1.75” Carriage Bolts 10
D Washer 1/4” 10
E Nylon Nut 10
# Parts Qty.
F Tie Bar 1
G Cable Tethering Pins 2
H Non-Marring Bumper Feet 2
Slide the Ladder Stabilizer step
brackets over the ladder rung until
they are in contact with the rung.
Slide tethering pins through the
step bracket holes making sure
that they also go through the hole
in the back of the step bracket.
E1117 Rev. 4-27-18