Instructions / Assembly

Blade Information - Replacement Blade #13807
This blade is made out of carbon steel and should not need sharpening. The blade is
reversible (front to back) and the cutting edge is a flat 90˚. If sharpening becomes
necessary make sure to sharpen at 90 degrees. Replacement blades are available.
Blade Replacement Instructions
1. Flip the Single Shaper upside down.
2. Using a set of pliers and a 18mm wrench remove the bolt that holds the
blade/tension spring.
3. Remove washers, spring and bolt.
4. Place the blade arm on it side.
5. Using a Phillips head screwdriver and a
7mm wrench, remove 5 sets of
screws along the cutting blade.
6. Flip the blade 180˚ or replace the old
blade with the a new one (Part #13807).
7. Replace the 5 sets of screws with
lock washers and nyloc nuts on
the cutting blade.
8. Reassemble the Shingle Shaper
according to the diagram below.
9. Tighten the spring nut with enough
tension as to effetely cut shingles.
Roof Zone is a Division of TIE DOWN ENGINEERING
Atlanta, Georgia 30336
[phone]
Bolt with Washer
(18mm)
Nyloc Nut
(7mm)
Lock Washer
Blade Bolt
Cutting Arm
Reversible
Cutting Blade
Shingle Shaper
Washers
Tension Spring
Nyloc Nut
(19mm)
TMTM
Page 4 of 4