Instructions / Assembly

ManualsBrandsRoof Zone ManualsBuilding materialsShingle Shaper - Shingle Cutter Replacement Blade

Part #13806

Shingle

Shaper

Safety First

Always keep hands and ﬁngers away from blade guard when using. Do

not use Shingle Shaper when the guard is not installed. Always secure

cutting blade in the closed position using locking pin when not in use.

Keep out of reach of children. When securing to roof, use hook bracket

for roof pitches steeper than 6/12.

E1363;060515

TMTM

Page 1 of 4

Reference Sheet #E1363

TIE DOWN ENGINEERING • Atlanta, GA 30336

www.tiedown.com (404) 344-0000

Summary of content (4 pages)

PAGE 1
TM Shingle Shaper Part #13806 Safety First Reference Sheet #E1363 Page 1 of 4 TIE DOWN ENGINEERING • Atlanta, GA 30336 www.tiedown.com (404) 344-0000 E1363;060515 Always keep hands and fingers away from blade guard when using. Do not use Shingle Shaper when the guard is not installed. Always secure cutting blade in the closed position using locking pin when not in use. Keep out of reach of children. When securing to roof, use hook bracket for roof pitches steeper than 6/12.
PAGE 2
Shingle Shaper Part #13806 TM Assembly Instructions Attach handle to the blade arm using a Phillips head screw driver. Tighten two screws through the handle to the blade arm. Cutting Methods: • Cut shingles with the granules up. • Hold shingles with free hand while cutting, this prevents the shingle from moving during cutting procedure. • Depending on shingle content and temperature, your method of cutting may need to change. For instance, faster, slower, more or less pressure, or chopping action.
PAGE 3
Upper Pivot Point (Push pin up from the bottom) Figure 1 Figure 2 Pivot Point Cleaning and Maintenance Blade and table surface should be cleaned periodically to remove any material build up which can affect the quality of the cuts. A cleaning liquid may be used. Grease may be applied occasionally to the blade pivot joint between the two cutting edges. This will help reduce wear and tear on the blades.
PAGE 4
Blade Information - Replacement Blade #13807 This blade is made out of carbon steel and should not need sharpening. The blade is reversible (front to back) and the cutting edge is a flat 90˚. If sharpening becomes necessary make sure to sharpen at 90 degrees. Replacement blades are available. Blade Replacement Instructions 1. Flip the Single Shaper upside down. 2. Using a set of pliers and a 18mm wrench remove the bolt that holds the blade/tension spring. 3. Remove washers, spring and bolt. 4.