Install Manual

Installation
7
PART C: Installation
1. Installation of Brackets
(1) Inspect the location
① Once you find where you want to install
RT- Roof Entry Bracket, please make sure
there are no cables, lights or any objects
under roofing and sheading.
② Location must be selected following
the condition from PART B,
installation condition.
(2) Marking the installation spot
① Using the template to mark the
location of the base. The base shall
be 1 3/16 inch (30mm) away from the
side edge of shingle roofing gap, 2 3/8”
(60mm) away from upper shingle
course. Mark the center of the hole.
Follow installation requirements to
avoid the risk of water leakage.
Attention
!
Hole location
■Guide sheet