Install Manual

Installation
17
(4) Install Roof Entry Bracket Cover
① Roof Entry Bracket Cover is installed
once all wiring or cable installation is finished.
Use the 3 Screw M4×16 with Star washer
provided to secure the cap.
(5) Apply the sealant around the base
① Seal around the base after the cover is installed. Sealant shall be installed
side and ridge side only. No sealant needed on the eaves side.
② Use sealant finishing tool to fill well between sealant and base. Make sure
there is no gaps.
Screw M4x16 must be installed hand
tight, do not use drills or any electrical
tools.
Attention
!
The sealant ads a layer of UV
protection and sheds water away.
Attention
!
■Screw M4×16
■Star washer M4
4
■Roof Entry Bracket cover
■Sealant