Install Manual

Installation

⑭ Locate the installing surface and place the

Roof Entry Bracket.

⑮ Install and secure Base with 3 screws

(Wood Screws 5.0×60（W/P）

Make sure base is tightly sealed to the

roof surface. No gaps underneath it.

Attention

Note: Proper torque values for the 5.0×60 mm screw will vary depending on the

rafter and/or deck characteristics; hardness, age, and moisture of the wood.

Tightend until the washer just stop rotating easily.

When tightening the screws please tighten all screws equally and avoid using an

impact driver as it can over torque the screws, damage the roof deck or even snap

off the screw head.

Attention

Socket or

Philips head

Washer

Rubber Washer

Bracket

Washer

Rubber Washer

Too loose

Too tight

Good

■Roof Entry Bracket base

■Wood screw 5.0x60