Install Manual

ADDENDUM
Installation Instruction for Metal Roofing
21
③ Peel off the protective paper from
the RT butyl tape.
④ Place the brackets at the
specified location and make sure
the RT butyl attaches well to the
roofing surface. Set the bracket
with 2 ea. (for RAFTER), or 5 ea.
(for Roof DECK), of 5.0×60 mm
stainless wood screw using 8 mm
socket. Slide the M8 or 5/16” Hex
bolt into place before fastening
the bracket on the roof [rafter
install]. After completing
process, make sure the brackets
are securely fixed.
Do not leave any protective paper
on the surface of the RT butyl tape,
it can cause an improper seal and
may allow water intrusion under
the bracket.
Attention
!
[Fastening to the rafter]
[Fastening to the roof deck]
When the MINI base is
installed on the deck, 5
screws must be used. The
screws are fixed into the side
4 holes and 1 ridge side hole.
Note; Each MINI is shipped
with 2 mounting screws. The
installer must purchase
additional screws when
mounting it to the roof deck.
Attention
!