Install Manual

Splice Installation

(5) Upper (Ridge side) End Splice Installation

Note: If the ridge side (top) base Bracket was rotated 180 degrees as

shown on Page 26, skip to ②’ and ③’.

① Untighten End Splice

Clamp Head cap screw

M10, and rotate the clamp

180 degrees.

② Slide the RT-APEX End

Splice until it is flush to

the frame of the panel

already installed.

③ Tighten the head cap screw

M8x9, on the bottom side

of the Pillar, to 106 in-lbs

(12 N･m) torque.