Install Manual

Splice Installation
51
③ Tighten the Head cap screw
M10 to 142 in-lbs (16 N･m) or
159 in-lbs (18N･m) torque (see
appendix for the proper torque
value).
④ If necessary, level the height of
the brackets using Hex wrench
bit socket (8 mm).
Adjusting height shall be done
within the range from bottom
where the Pillar hits the clamp,
to the top where the pillar is
flush to the top of U-D bracket.
Adjustable height is up to 1”
(30mm frame), 1 3/8” (40mm
frame).
Max height line