Install Manual

LANDSCAPE
PANEL INSTALLATION
33
(4) Upper End Clamp (Ridge side) Installation
Note: If the ridge side (top) base Bracket was rotated 180 degrees as
shown on Page 26, skip to ②’ and ③’.
① Untighten the end clamp cap
screw M10, and rotate the end
clamp only. Set the screw on
the same side.
② Slide the RT-APEX end clamp
until it is flush with the frame.
③ Tighten the head cap screw
M8x9, on the bottom side of
the pillar to 106 in-lbs (12
N･m) torque.