Install Manual

LANDSCAPE
BRACKET INSTALLATION
26
Eaves
⑦ [OPTIONAL Sealant Layer] Cover the exposed RT butyl tape with
roof sealant. Apply roof sealant around the brackets, the top and
each side edge of the brackets. The purpose for the sealant is to add
a layer for UV protection.
It is not necessary to seal the bottom of the brackets.
※Optional installation on the Ridge (top row) of the array only!
(See Pg. 33)
This option allows for the end clamp to be installed on the ridge side
without removing the top/ridge side clamp only. Rotating the entire set
(base and top ridge end clamp) 180 degrees, eliminates the need to
remove and rotate the End Clamp from the U-D base.
The screw location for
Rafter Installation
The screw location for
Deck Installation