Install Manual

ADDENDUM
Installation instructions on composite slate
79
3. Bracket Installation
① Drill a pilot hole to fill with sealant with a φ1/4 inch (φ6.5 mm) drill
bit at the markings.
Note：It is easier to manage drill depth by using any stopper on the drill
bit. Please make sure to use stopper to drill through the layer of roofing
material only. Do not to drill all the way to the wood deck or
underlayment.
② Fill the cavity with a sealant
listed in our Installation
Manual. The sealant must
be flush with the slate
surface.
You must avoid drilling into the
wood underneath it.
Attention
!