Install Manual

LANDSCAPE

BRACKET LAYOUT

① Chalk line according to the layout plans

to indicate brackets position.

(i) Line Y0: Position the lower base

upper edge at 3/16” (5mm)

from the edge of the upper

composite shingle.

(see illustration bellow)

(ii) Line Y1: Delineates the location of the

Pillar Bracket’s eaves side for

the first row at 4-1/8” (105mm)

from Line Y0 (upper edge of

base bracket).

(iii) Line Y: Center of brackets of the second and subsequent rows. The

distance between Y1-Y and Y-Y shall be the width of panel

(refer to Pg. 14 illustration) plus 1-1/16” (27mm, equivalent to

the width of a Panel Spacer and middle clamp).

(iv) Line T: It delineates the center line of the spacing between adjacent

rows. The distance between T Lines shall be the length of a

panel (see illustration from Pg.14) plus the spacing between

rows. We recommend a minimum of 1/8” (3mm) spacing

between adjacent rows to allow for thermal contraction and

expansion.