Install Manual

Tools Required for Assembly

Technical Note

Tools Required for Assembly

Tools needed for installing the RT-MINI Ⅱ

・Hex bit socket (8mm)

・Drill andφ3 mm Drill Bit or Center punch for sheet metal

(for Installation on Metal Roof)

・Measuring tape

・Chalk line

・Torque Wrench

※L-Foot mounting option

Item Torque

RT2-04-FBN 25 SL-5/16 Flanged Bolt

and Flanged Nut

15.8 N･m (140)

※Accessory mounting option

Item

Torque

W1/4 Carriage Bolt 6 N･m (53)

Technical Note

Proper torque values for a wood screw will vary depending on the rafter and/or deck

characteristics; hardness, age, and moisture of the wood. Tighten the M5x60mm

wood screws until the conical washer stop rotating.

Stainless hardware is soft and if dry torqued too quickly it may cause the nut and

bolt to seize.

Roof Tech recommends all stainless steel threads be lubricated. This will make it

easier to tighten nuts to bolts, avoid galling, and facilitate adjustments before the

nut is properly torqued. Therefore, avoid the use of an impact driver.

When driving the RT 5x60mm or 5x90mm into the wood, always keep a hand

pressure on the RT MINI II in order to avoid the base being pulled away from the

roof surface.