Install Manual

ADDENDUM

Installation Instruction for metal roofing

2. Marking on the Roof

(1) Layout

① The MINI Ⅱ base must

be mounted on the flat

surface. Please make sure

the location is not on slope

surface of metal ribs.

Screw must be fixed to the

flat surface. Also, its center

must clear 5mm from the

edges （Please refer to the

3 pictures on the right.）

② In case of Deck Installation,

mark at ± 15 mm, ± 25

mm from the intersection of

the M Line and Y Line.

③ Then mark at ±32.5 mm

from the M Line

④ Mark at ＋35 mm from the

Y Line on the M Line.

[Fastening to the Deck]

Note; Marking spot is not symmetric when MINI Ⅱ base is

installed on deck. You may want to have an extra MINI Ⅱ

to assist in marking to a metal roof. (Create a MINI Ⅱ JIG

by removing the RT Butyl from it.)

Attention