Install Manual

Bracket Installation

[Fastening it to the Roof Deck]

When the MINI Ⅱ base

is installed on the deck, 5

screws must be used.

Four screws are fixed into

the sides and 1 on the

ridge side.

Note; Each MINI Ⅱ is

shipped with 2 mounting

screws. The installer

must purchase additional

screws when mounting it

to the roof deck.

Attention

Note: Proper torque values for the 5.0×60 mm screw will vary depending on the

rafter and/or deck characteristics; hardness, age, and moisture of the wood. It

should be tightened until the conical washer stops rotating..d until the conical

washer stops rotating.

When tightening the screws please tighten all screws equally and avoid using an

impact driver as it can over torque the screws or even snap off the head.

Attention

Socket or

Phillips head

Washer

Rubber Washer

Bracket

Washer

Rubber Washer

Too loose

Too tight

Good