User Manual

ManualsBrandsRonbow ManualsSoftwareMotion Sensor LED Light

RONBOW CORPINSTALLATION GUIDE ronbow.com

INSTALLATION SHEET

MOTION SENSOR LED LIGHT

ACCESSORIESMODEL: 710024-NF

710030-NF

Motion sensor LED light upgrade is available for the Ariella, Vanessa, Jenna and Chloe collections.

It is recommended to have an available wall outlet near the cabinet. It may be located either on the back wall or

underneath the cabinet.

SPECIFICATIONS:

• Inputvoltage:DC12V

• Drivingpower:<36W

• LEDstrip:Lighttemperature:4200K

MOTION SENSOR:

• WhenthedraweropenstheLEDlightturnson.WhenthedrawerclosestheLEDlightturnso.

• Inputwirelength:3-1/4feet

• Outputwirelength:1foot

NOTE:

• Workingenvironmenttemperatureshouldbe-5°C~40°C.

• ThisLEDisnotwaterproof.Avoiddirectcontactwithwater.

• Motionsensorissensitivetodirectsunlight.Avoidplacingmotionsensorinextremetemperatureordirectlight.

Failingtodosomayresultindamagetothesensortechnology.

Infrared Motion SensorLED Strip

DC OUTDC IN

6’

Output: 1 foot

Input: 3-1/4 feet

Summary of content (4 pages)

PAGE 1
MOTION SENSOR LED LIGHT MODEL: 710024-NF 710030-NF INSTALLATION SHEET ACCESSORIES Motion sensor LED light upgrade is available for the Ariella, Vanessa, Jenna and Chloe collections. It is recommended to have an available wall outlet near the cabinet. It may be located either on the back wall or underneath the cabinet.
PAGE 2
MOTION SENSOR LED LIGHT MODEL: 710024-NF 710030-NF INSTALLATION SHEET STEP 1: Locate the recessed wood behind the front ACCESSORIES Figure 1. support. Recessed wood for LED See Figure 1. Front support Left side wood panel STEP 2: Using the (2) brackets and screws supplied place a bracket on each side of the recessed wood. Figure 2. See Figure 2.
PAGE 3
MOTION SENSOR LED LIGHT MODEL: 710024-NF 710030-NF INSTALLATION SHEET STEP 5: Place the LED circuit box in a discreet location by removing the 3M backing. ACCESSORIES Figure 5. 3M Backing See Figure 5. Wire to power adapter STEP 6: Plug the DC out from power adapter to Wire to motion sensor Figure 6. DC in from LED circuit box. See Figure 6. DC Out DC IN LED circuit box Infrared motion sensor STEP 7: Plug in the power adapter to the wall outlet.
PAGE 4
MOTION SENSOR LED LIGHT MODEL: 710024-NF 710030-NF INSTALLATION SHEET ACCESSORIES hardware INSTALLATION STEP 1: Remove the wall plug section from the wire by cutting the wire. Figure 1. See Figure 1. Note: Recommend licensed electrician. A low voltage transformer will be required. Cut at dotted line STEP 2: Using wire snippers, remove a portion of the plastic cover to reveal the wires. Figure 2. See Figure 2.