User Manual

REV. OCT, 2013ronbow.comINSTALLATION GUIDE

INSTALLATION SHEET

ACCESSORIESMODEL: 618523

619623

LED AnD MEtAL MEDICInE CABInEt

MATERIALS NEEDED:

PHILIP SCREWDRIVER

STUD LOCATOR

LEVELING TOOL

MATERIAL PROVIDED:

(4)WOOD SCREWS

(4)MOUNTING HARDWARE

(2)GLASS SHELVES

(8)MOUNTING HARDWARE FOR SHELVES

NOTE: locate the wire at the top of the cabinet. The qualiﬁed license electrician has the option to plug into a wall outlet, or hard

wire the cabinet by cutting the plug.

Circuit Breaker

If your new medicine cabinet has a built-in led then follow the section below.

ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENSED ELECTRICIAN.

WARNING: To reduce the risk of electrical shock, shut o power before wiring the cabinet.

CAUTION: Requires 120V 20AMP circuit.

CAUTION: This product must be connected to a grounded, metal permanent wiring system or an equipment-grounding

conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lean on the product.

CAUTION: A LED option cabinet must be wired to a 20AMP GFI (ground fault interrupter) circuit breaker when used in

bathrooms and all other locations required by the national electric code.

Wall Terminal

Black Black

White White

Ground

20AMP CFI

PAGE 1
LED and metal MEDICINE CABINET MODEL: 618523 619623 ACCESSORIES INSTALLATION SHEET MATERIALS NEEDED: MATERIAL PROVIDED: PHILIP SCREWDRIVER STUD LOCATOR LEVELING TOOL (4)WOOD SCREWS (4)MOUNTING HARDWARE (2)GLASS SHELVES (8)MOUNTING HARDWARE FOR SHELVES If your new medicine cabinet has a built-in led then follow the section below. All wiring should be done by a qualified licensed electrician. Warning: To reduce the risk of electrical shock, shut off power before wiring the cabinet.
PAGE 2
LED and metal MEDICINE CABINET MODEL: 618523 619623 ACCESSORIES INSTALLATION SHEET SURFACE MOUNT INSTALLATION STEP 1: Determine the ideal location of your new Figure 1. metal medicine cabinet. Make sure cabinet has enough clearance from faucet and ceiling. Minimum to Ceiling 1” Note: LED option (model 619623) see page 1 for electrical connection. See Figure 1. Minimum to Faucet STEP 2: It is strongly recommended the cabinet is Figure 2. 1” 16” mounted to studs with the wood screws provided.
PAGE 3
LED and metal MEDICINE CABINET MODEL: 618523 619623 STEP 4: Slide hardware on the top rail. Match the ACCESSORIES INSTALLATION SHEET Figure 4. distance of the metal mounting hardware to the wood screw on the wall from step 3. de Sli See Figure 4. STEP 5: Mount the cabinet to the wall by lining up the metal mounting hardware to the wood screws on the wall. Figure 5. Screw in wall Note: Tighten wood screws to secure cabinet.