Installation Guide

RONBOW CORPINSTALLATION GUIDE ronbow.com

INSTALLATION SHEET

ABOVE COUNTER SINKSMODEL: 200271 217732

217724 217737

CERAMIC VESSEL

STEP 1: Place adhesive around top of cabinet

Position countertop opening to ensure

clearance between the lavatory, faucet and

backsplash.

Note: If using a custom top, position and drill a 7

inch hole in the counter top.

See Figure 1.

Figure 1.

STEP 2: Place a generous portion of plumb-

ers' putty under drain cap and insert whole

drain body inside the bowl and through the

countertop.

(There may be a small beveled rubber

washer packaged with your drain, please

discard this and use plumbers' putty in-

stead.)

See Figure 2.

Figure 2.

Note: For ceramic sinks with overﬂow & faucet deck

Drain Cap

Thick Rubber

Washer

Metal Nut

Overﬂow Hole

Tailpiece

continued...

STEP 3: When placing overﬂow drain into the

bowl, make sure the overﬂow hole lines up

with overﬂow drain hole in the sink.

See Figure 3.

Figure 3.

PAGE 1
CERAMIC VESSEL MODEL: 200271 217724 INSTALLATION SHEET 217732 217737 ABOVE COUNTER SINKS Note: For ceramic sinks with overflow & faucet deck STEP 1: Place adhesive around top of cabinet Figure 1. OR Position countertop opening to ensure clearance between the lavatory, faucet and backsplash. Note: If using a custom top, position and drill a 7 inch hole in the counter top. See Figure 1. STEP 2: Place a generous portion of plumb- Figure 2.
PAGE 2
CERAMIC VESSEL MODEL: 200271 217724 INSTALLATION SHEET 217732 217737 STEP 4: From under the drain, insert the ABOVE COUNTER SINKS Figure 4. thick rubber washer and screw on and tighten the metal nut. Remove excess plumbers' putty. Drain See Figure 4. STEP 5: Attach p-trap to tailpiece. Thick Rubber Washer MATERIALS NEEDED: Drain Nut PHILIP SCREWDRIVER PLUMBERS' PUTTY/ SEALANT Tailpiece P-Trap INSTALLATION GUIDE ronbow.