Owner's manual

Density Gage Manual 012407
11
Calibration
State [state]
Ref Constants Ref Constants
Calibrate
Last Ref Date [date] Ref Mode [variable]
Last Ref Time [time] Calibr. Mode [variable]
Loop Config Ref Time [time]
Aux Loop Cfg Min Ref Cnts [counts]
Max Ref Cnts [counts]
Calibrate Low Reference
Low Reference Reference
High Calibrate Ref Density [value units]
Manual Entry Ref Cap [counts]
Clear Ref/Cal
Temp Ref High Calibrate
Pressure Ref
Auto Reference Calibrate
Cal Density [value units]
Loop Config Cal Cap [counts]
1/uT [slope]
PV is [variable]
Loop test Manual Entry
Damping
D/A trim 1/uT [slope]
Aux Loop Config Temp Reference
SV is [variable] Temp Ref
Aux 1 Test Temp Cap Low [counts]
Aux 1 Trim Temp Cap High [counts]
TV is [variable]
Diagnostic Pressure Reference
Raw Counts Ref/Cal Data Pressure Ref
Filt. Counts Pres Cap Low [counts]
Raw Dens. Last Ref Date [date] Pres Cap High [counts]
Current Ref Density 0
Ref/Cal Data Cal Density 2 Auto Reference
Alarms Ref Cap
Cal Cap Auto Ref [enable]
Last Ref Temp Ref Delay [s]
1/uT Auto Ref Density [SGU]
Alarms
Sys. Alarm
Empty Clamp
Det. Fault
AutoCal Ref
AutoCal Error
Ref. Prompt
Wipe Test
Shutter Test
Alarms
Output
Figure 3-5 – Calibration Menus