User Manual

ManualsBrandsRoMech ManualsCuttersElectric Rope Cutter with Adjustable Power - Hot Knife Thermal Blade for Braid Fabric Webbing Belting Ribbon- Bench Mount Cutting Tool Kit – Heal Sealer (120W, RM-025)

SAFETY & WARNING

To use the unit safely, it must be set up and operated in accordance with

the instructions in this user manual. Please read the safety precautions,

to prevent harm to you and others, and to avoid damage to the tools.

• Before use, make sure the set is complete and the machine is in

working order

• Don’t use the cutter if damaged. Contact your supplier for

assistance

• Operate with caution, wear eye goggles

• Do not force the machine during cutting

• Keep the workplace clean, away from flammable materials.

• Keep the machine away from moisture and rain

• Regular checks and maintenance are required

• Keep the machine away from flammable and explosive

substances

• Do not use the machine to warm up liquids

• Keep your hands or other parts of your body away from hot blades

• Never operate the machine under the influence of drug or alcohol

• Packaging should be kept away from children for potential choking

hazard

OPERATION INSTRUCTIONS

Getting Ready

• Unscrew the lock screw

• Install the blade into the blade holder, and tighten the lock screw

• Inspect the blade and blade holder, make sure they have full

contact. If not, please repeat the steps above

• Plug into a standard 110V outlet

Note: Blade must be firmly in place and properly tightened down to

complete the circuit or the cutter will not turn on.

Cutting

• Turn on the cutter

• Put the cutting target on the hot blade, then press it down.

Be cautious and keep body parts away from the hot blade.

• Turn off the cutter after finishing the task

Warning:

• Before cutting fabric/rope, please carefully read the material

manufacturer’s instructions on the inflammability and toxicity of

the material.

• Use the unit in well-ventilated rooms. If possible, use ventilation

equipment.

• Turn off the trigger when the unit is not being used. Leaving the

trigger on will overheat the blade and the unit which may result in

the blade deforming. Please refer to “Blade Cleaning Instructions”

when cleaning the blades.

• Do not contact the hot blade with skin, clothing, and other

combustible items, to avoid fire and injury.

BLADE CLEARNING INSTRUCTIONS

1. If fabric/rope builds up on the cutter after use, unplug unit and let

cool completely.

2. Disassemble blade from cutter.

3. Spray with carburetor/starter fluid and gently scrub the blade

using the soft wire brush or steel wool until buildup is removed.

Caution: In the event fabric/rope builds up on the cutter, DO

NOT ATTEMPT TO BURN OFF.