Specifications

UHP-1000 SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.5

(SW VERSION 2.5.X)

4. MAINTENANCE

In many cases, reinstalling system software allows to restore a satellite router functionality (see Section 3.2), which

may need reset to the factory default configuration (see Section 4.2).

If the recovery of software cannot be implemented successfully, or if this operation does not eliminate the defect,

it is necessary to illuminate the faulty device accordingly to the Section 2.15.4 and replace it by new device.

4.1 Replacement of modules

4.1.1 Common recommendations

Repair of satellite router is carried out by replacing defective units (PSU or a router) or the whole product.

Replacement must be carried out only on original and compatible units, supplied by the manufacturer. After

replacing the power supply the router is immediately ready for further operation. In case of a satellite router

replacement it has to be reconfigured to the network parameters in accordance with Section 2.2.

4.1.2 Safety instructions

Repair by replacing blocks of satellite router must be carried out by qualified personnel only and with powered off

device only.

4.2 Resetting to default settings

To reset user settings you can make use of a special restart procedure. Press RESET button four times with 2

seconds intervals.

Figure 26 Router resetting to default procedure

Successful reset will be evidenced by fast and simultaneously flashing indictors ERROR and STATUS.

By default, UHP-1000 router is provided with IP-address 192.168.222.222 with mask 255.255.255.248 (/29).

Respectively, the computer should be provided with an address, e.g. 192.168.222.217 with the same mask.

The default address is not shown in the route Table. And what is more, it disappears after the first saving of the

configuration. Thus the first thing to do, with the Telnet access, is to set a new IP-address (it may be similar to the

default address when required), exit the session, and connect to the new address and only then save the

configuration.

After the first saving of the configuration the ERROR and STATUS indicators stop flashing simultaneously.

Push reset Push reset Push reset

Push reset

Factory default reset

Push reset

Normal reset