Specifications

UHP-1000 SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.5

(SW VERSION 2.5.X)

Default action – list through the banks in sequence and download the first bank in which SW will be with the

correct checksum, having used the zero configuration profile.

You can change the loader behavior by specifying directly the number of the bank which should be used to start

SW, and the configuration profile number.

When the router SW is updated you have the possibility of verification of the new SW performance without finally

transiting to it. To do so, you can start new SW once and if there are any problems (e.g. Hub communication is

unavailable), the router will in some time reboot back to the old SW or in any case or if it failed to establish

communication with the Hub. This procedure is named fallback. If, when working with the temporary SW, the

router is overloaded with user’s activities it will also get loaded in the main SW.

To implement this fallback mechanism, you have to specify which bank should be used to download the main SW

from and which - the temporary SW.

Figure 25 Router reboot procedure

Reboot procedure control commands write the configuration not in the configuration profile but in a separate

place. Changes come into force immediately after the command is entered and no save operation is required.

boot main 0-3 0-1 - Main boot profile FLASH_BANK(0-auto) CONF_BANK

The command selects the main bank for reboot. The first parameter for the bank is SW, the second –

for the configuration profile.

boot temp 0-3 0-1 - Temp boot profile FLASH_BANK(0-none) CONF_BANK

Same for the bank with temporary SW.

boot fallback timeout 1-10000 - Temp image auto fallback period (min)

Delay in minutes prior to possible reboot back to the main bank.

boot fallback reason uptime|link-up - Auto fallback reason

After the delay, reboot occurs either in any case or if the station failed to establish communication

with Hub.

RESET

Autoselect of

bank

Main=0, Temp=0

RESET

Select

Main

Main>0, Temp=0

RESET

Select

Temp

Temp>0

Delay

Reset

No HUB

connection

AutoRestart

Select

Main

Software launch