Specifications
UHP-1000 SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.5
(SW VERSION 2.5.X)
© ROMANTIS 2012 58 www.romantis.com
server Router acts as a server, responding to client’s request with its time counter
both Combined mode, when router asks external server for time and may respond to other
clients too
If router acts as a client or combined mode the command "time sntp access" defines IP address of the
respective SNTP server.
time sntp access IP_ADDR [0-1023] - SNTP server access IP VLAN
where,
IP_ADDR IP address of SNTP server
[0-1023] VLAN routing table to be used for accessing the SNTP server
2.15.10 Additional commands
watchdog reset|interrupt - Watchdog timer overflow action
Debugging service command.
reboot [0-1000] - Reboot device [delay in minutes]
Router reboot. If configuration has been changed but not saved, all the changes will be lost.
Command without parameter initiates immediate reboot after confirmation. If parameter is specified
delayed reboot is initiated. This is a fail-safe measure before any critical configuration changes to
allow auto-recovery if configuration will be screwed-up.
reboot stop - Stop delayed reboot
Abandon delayed reboot.
reboot auto 0-120 - Reboot if TDMA down [delay/minutes, <5 - disable]
Perform automatic reboot if there is no link to hub. Current setting is shown in «show system»
printout.
time shift -24-24 - Local time zone
Difference in time zone with Hub.
time set 0-24 0-60 1-31 1-12 0-99 - Set date/time HH MM DD MM YY
Set local time on the router. Time is lost upon reboot.
2.15.11 Controlling router status
Enter router’s IP address into Internet browser to access to connect to a monitoring and control page of the router
(see Figure 13). Switch to the “Status” page for actual status of the router and its interfaces. The page will be
automatically updated every 5 seconds. “Refresh” link allows manually updating the page on request.
Alternatively, the current status of the router can be accessed through a console with the following commands:
show interface ethernet|tdma|demodulator|modulator - Interface stats
Displays settings and statistics of respective interface
show log - Display logs
Displays a log of events (from latest to newest)
2.15.12 Traffic diagnostics
---------- Diagnostics
ping IP_ADDR [1-1000000] [36-1470] [1-10000] [0 - 1020] - IP Number Size
Interval(ms) [VLAN]
Sending PING request. The router can send up to 1000 packets per second.
Packet size (In contrast to WIN, LINUX) should be specified together with IP and ICMP protocol
headers.
Example of PING command: