Specifications

UHP-1000 SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.5
(SW VERSION 2.5.X)
© ROMANTIS 2012 56 www.romantis.com
config load 0-1 - Load configuration from specified profile
Loads one of the saved profiles in the current one.
config save 0-1 - Save current configuration to specified profile
Saves the current profile (zero at the command’s end may not be entered).
show config - Show current configuration
Prints out current configuration.
show memory ram|flash|eeprom - Show memory state
Prints out configuration profile list in eeprom.
2.15.6 Events (LOGGING)
UHP-1000 router generates messages with the changes that show the router subsystems state. These messages
are as follows:
o System messages on restart, saving configuration, etc.
o Messages on changes in the interfaces state
o Messages on changes in the stations status (for CS).
Examples of events:
+00:00:01 Interface Demodulator enabled
+00:00:01 Interface Modulator enabled
+00:00:01 Interface Modulator UP
+00:00:02 Interface Demodulator UP
The first to be displayed is the time stamp. If the router time is synchronized with the Hub (this occurs
automatically), the current time is generated with the account of the time zone which is set on the router. If
synchronization is missing, the time stamp starts with the + sign to signify the time that have passed since the
router was switched on.
All messages are sent to the current console, plus part of them that has been selected by the user (be default – all),
written in the non-volatile memory and saved during restarts.
show log - Display logs
Look message log through (old messages printed first).
clear log - Purge logs
Clear the log.
logging interface|demod|config|system enable|disable - Logging events
Permit or prohibit entering various message types in the log.
2.15.7 Limitations to access to the router
UHP-1000 router is provided with two privilege levels – User and Administrator. The User has access to the entire
statistics but cannot change router configuration. Two passwords to log in the router are set. User password closes
access to the router over Telnet and console. If, in this case, Administrator password is not set, by entering user
password the logging-in person obtains administrator access. This is the most convenient mode. If it is necessary to
differentiate the access to the router on both levels, you have to issue the «admin» command and enter the
second password to obtain administrator rights. In the latter mode, if only administrator password is set, anyone
can log in without password and see statistics, and for the administrator mode – make use of the «admin»
command.
These passwords are used also for WWW-access.
admin - Switch to Administrator mode
Switch over to administrator mode.
password user|administrator - Set passwords
Change or switch off password. If you afterwards press “enter” button two times, the password will
be reset.